ST89 Ceiling PIR Lamp

Instructionn

SUMMARY

This product is an energy automatic ceiling PIR lamp, it can identify day and night. It adopts infrared detector, IC and SMD technology, when someone enter its detecting range, the infrared detector turn on the lamp, after he leave its range, the lamp will turn off automatically.

FEATURES

¡¤Adopts 8-bit DIP switch:
¡¤You can select working light to work only in the light below 10lux or in any light;
¡¤Adjustable sensitivity;
¡¤Choose working time-delay of the load: 5s, 30s, 1Min,3Min, 5Min, 8Min.
¡¤The time that the load work can delay automatically: it re-computes time after the last sensing.

TECHNICAL INDEX

sense range:angle 360¡ã,6m.max(diameter)
Power supply: 180~240V/AC
110~130V/AC
rated load:22W
working temperature:¨C10¡æ~ +40¡æ
working humidity:¡Ü93%RH
time-delay:5s¡¢30s¡¢1Min¡¢3 Min¡¢5 Min¡¢8 Min.

Working light : <10LUX~2000LUX

INSTALLING

¡¡

• Take downthe decorating ring by turning it anti-clockwise, like the right diagram-1;
• According to the right diagram-2 loosen those lock-buttons on base and take off the lamp cover;
• Connection-wire: Connect N(blue) and L(brown) with power;
• Install the base on the needed position; ;
• Close the lamp cover, and button up the lock-buttons on base, and then turn clockwise the decorating ring and lens.

¡¡

DIP SWITCH SETTING

1£®Working light()selecting:
        ¡¤when no slide to ON, it can working in any light degree;
        ¡¤when slide to ON, it can only work at night(<10LUX).
2. Sensitivity () selecting:
       ¡¤when no slide to ON, High sensitivity;y;
       ¡¤when slide to ON, Low sensitivity.

3. Time-delay (5"£¬30"£¬1¨@£¬3¨@£¬5¨@£¬8¨@)

if you want to select a certain time-delay, you only slide it to ON position.

SENSE RANGE FIGURE

TESTST

¡¤Slide DIP 5¡åto ON position and other is on original position;
¡¤Switch on power, the lamp turn on. After the lamp turn off, the sensor enter stable working state;
¡¤Sense it once, the lamp turn on, and after 5s it turn off automatically;
¡¤If slide DIP() to ON position, test it in the daytime, sense it, the lamp will not be on, cover the sensitization resistor with opaque object, sense it once again, the lamp will be on, and after 5s it turn off automatically;
¡¤When time-delay is not chosen, sense it, the lamp will light for a long time and then go out.t.

¡¤The installing personnel should be electrician or with correlation experience;
¡¤Be sure not to install the unit in the place where sun shine, current and temperature change obviously, for example air conditioning, air warm;
¡¤Do not choose the sway object as installing base;
¡¤In front of sense range there should be no obstruction or moving object to influent its detecting.